50m Drip Hose 16mm, Garden Irrigation Hose

The hose is designed for installation on the ground to direct the water directly to the roots. Use in raised beds is easily possible when it's lying on the ground.

The drip hose requires a water pressure of 1.5 bar for the specified output of 2 l/h. A direct connection to a rainwater tank without a pump usually does not provide sufficient pressure.

The drip hose delivers 2 liters of water per hour per drip point. For a 40-meter hedge, that's about 121 drip points, which together deliver about 242 liters per hour. The sufficient amount depends on the specific water requirements of your hedge.

The 50 m drip hose is designed for even water flow for this length. An extension beyond 50 m is possible with the appropriate connectors and a sufficiently dimensioned water supply.

The construction of the drip nozzles is designed to prevent the ingress of impurities into the interior of the drip hose. Additional filtration of the water is not absolutely necessary in most cases.

The 50m drip hose has about 151 drip nozzles (50m / 0.33m). With an output of 2 l/h per nozzle, the hose thus uses around 302 liters of water per hour. (Roughly calculated: 151 nozzles x 2 l/h).

Yes, the design of the HYDRO™ drip nozzles ensures an even water flow over the entire length of the 50-meter hose. This ensures constant irrigation from beginning to end.

The outer layer of the drip hose is chemical-resistant. Application of liquid fertilizer is technically possible, but compatibility with the hose material should be checked.

The drip hose enables the automation of the irrigation process and is designed for a constant water flow. A regular, but not daily visual inspection is sufficient to ensure the function.

Yes, the drip hose is ideal for young plants. The precise, ground-level irrigation prevents overwatering or damage to delicate leaves and roots.

Yes, the HYDRO™ drip hose allows the automation of the watering process. It can be connected to a suitable timer and water source.

The 50m drip hose has a drip nozzle spacing of 33 cm. Thus, there are approximately 151 drip points along the entire length. (Roughly calculated: 50 meters divided by 0.33 meters distance gives the number of nozzles.)

Yes, the drip hose can easily be laid under a layer of mulch. The water is directed directly into the soil, which further reduces evaporation and keeps the irrigation efficient.

The drip hose is not frost-resistant and should be completely emptied and dried, stored in a frost-proof place before the first frost. Residual water can damage the hose in frost.

The output of 2 l/h per nozzle is guaranteed at 1.5 bar. With significantly lower water pressure, the ejection quantity of the drip nozzles may be reduced and the uniformity may suffer.

Yes, the hose can be shortened if necessary. However, please note that you will need a suitable end plug and possibly new connectors for the end of the shortened hose.

Yes, the drip nozzle output of 2 l/h is achieved at 1.5 bar, which corresponds to typical household water pressure conditions. A constant pressure supply is important for optimal performance.

The HYDRO™ can also be used in flower pots on the balcony. The ground-level irrigation is also efficient here, as long as the hose is laid at the bottom of the pot.

Yes, the drip hose also saves water with short watering times. Evaporation is minimized by the direct supply to the soil, and the water is used efficiently, compared to conventional methods.

The special design of the drip nozzles prevents the ingress of impurities and ensures a uniform flow of water. This significantly reduces the risk of clogging.

Yes, the drip hose is suitable for slight slopes. The water is precisely and directly channeled into the ground, which reduces runoff. Pay attention to secure fixing of the hose.

Yes, the outer layer of the drip hose is UV-resistant. This ensures a long lifespan, even with intense sun exposure.

The 2 liters per hour per nozzle is a precise and efficient amount for many plant cultures, including strawberries. The optimal watering duration depends on the specific water needs of the plants and the soil permeability.

The drip hose directs the water directly into the soil at the drip nozzles. The watering takes place locally around each nozzle and spreads in the soil. The exact watering radius depends on the soil conditions.

The 50m drip hose HYDRO™ has a drip nozzle every 33 cm. With this you can precisely water about 151 plants (roughly calculated: 50 m / 0.33 m = ~151 nozzles).

Yes, the drip hose is designed for mounting on the ground. It should only be fixed so that it maintains its position and does not slip, for example with ground anchors.

Yes, the drip hose directs the water directly into the soil to the roots. This promotes optimal growth and is therefore also well suited for plants with shallow root systems.

Yes, compared to conventional irrigation methods, you save up to 70% water with the drip hose. The targeted delivery directly to the roots reduces evaporation.