Stainless Steel 90 Degree Elbow, 1/2 Inch Threaded Pipe Fitting

Yes, the 1/2 inch threads are manufactured according to the common standards ISO 7-1/EN 10226-1. Therefore, they fit the standardized connections of bathroom faucets and similar components.

The wall plate is made of cast iron, but it is galvanized. This surface treatment effectively protects the material from rust and corrosion, even when in contact with water.

Yes, the threaded connections are not self-sealing. For sealing, you should use suitable material such as PTFE thread seal tape or thread seal hemp.

Yes, the threads of the wall plate are manufactured according to the common standards ISO 7-1/EN 10226-1 and ISO 228-1. They are thus compatible with standardized European pipe threads.

Yes, this 90° wall plate is ideal for mounting on a wall and suitable for conveying liquids. It has two 1/2 inch internal threads for connection.

Yes, the 1/2" IG x 1/2" IG wall plate is designed for conveying liquids and is suitable for installing a fixed outlet with a 90° bend on the wall.

Yes, the 90° wall bracket is made of robust galvanized cast iron. It is designed for system installation and withstands common mechanical loads or light impacts in everyday life.

The threaded connections are not self-sealing and must be sealed. For this, you can use either Teflon tape (PTFE thread seal tape) or thread seal hemp. Both materials are suitable.

The wall plate is suitable for the conveyance of liquids and gases. It has DVGW approval, which confirms its suitability for gas and drinking water installations.

Yes, the malleable cast iron fitting is approved for gas transmission and withstands operating pressures up to 25 bar. It is therefore suitable for compressed air lines in workshops.

The wall plate is galvanized, which provides good corrosion protection. For permanent outdoor use under direct weather conditions, the galvanization is usually sufficient and protects the cast iron.

Yes, this threaded fitting is DVGW-approved and specifically designed for gas installations. It meets the requirements for use in natural gas lines in the house.

Yes, the wall plate is suitable for hot water installations in heating systems. It withstands temperatures from -20°C to 120°C at an operating pressure of up to 25 bar and has DVGW approval.

Yes, the threads of the fitting are manufactured according to the common standards ISO 7-1/EN 10226-1 and are typically given in inches. It is a 1/2 inch internal thread.