Malleable Iron Pipe Fitting Cross, 1 1/2 Inch Female Threaded, Galvanized

The cross piece has threads according to ISO 7-1/EN 10226-1 for internal and external threads and ISO 228-1 for union nuts.

The crosspiece can withstand a maximum operating pressure of 25 bar at temperatures up to 120°C.

Yes, the cross fitting is suitable for heating systems, as it has a maximum operating pressure of 25 bar at temperatures up to 120°C.

The crosspiece is made of cast iron and is galvanized, but chemical resistance should be checked on a case-by-case basis.

Yes, the crosspiece is galvanized and provides good corrosion protection.

Yes, the crosspiece is suitable for compressed air systems as it supports a maximum operating pressure of 25 bar.

Yes, the crosspiece is suitable for use in air conditioners, as it is designed for temperatures from -20°C to 120°C.

Yes, the crosspiece is suitable for use at gas stations as it is approved for gas installations.

Yes, the crosspiece is suitable for use in refrigeration and air conditioning systems.

Yes, the crosspiece is frequently used in industrial plant construction and mechanical engineering.

Yes, the crosspiece is made of cast iron and has a tensile strength of less than 350 N/mm².

Yes, the crosspiece is suitable for temperatures up to 300°C, but the maximum operating pressure is reduced to 20 bar.

Yes, the crosspiece is galvanized and thus protected against corrosion, which allows its use in underground pipes.

Yes, the cross fitting is DVGW-certified and thus approved for use in gas installations.

For sealing the crosspiece, PTFE thread seal tape or thread seal hemp can be used.

Yes, the cross fitting has DVGW approval and is suitable for drinking water lines.

Yes, the cross fitting is intended for use in sprinkler systems.

Yes, the threaded connections are not self-sealing. It is recommended to use Teflon tape or hemp for sealing.

The durability depends on the usage conditions, but the cast iron and galvanization provide good corrosion resistance.

The crosspiece meets the standards DIN EN 10242 and ISO 7-1/EN 10226-1, as well as ISO 228-1.

Yes, the crosspiece has DVGW approval and is therefore suitable for gas installations. The threads are standardized according to ISO 7-1.

To seal the Whitworth pipe thread, you need a suitable thread sealing material. Hemp or Teflon tape, suitable for the 1/4 inch thread size, are appropriate.

For sealing the threads, you will need suitable thread sealing material. Hemp or Teflon tape are suitable for this purpose, but these are not included in the delivery.

Yes, the cross fitting has a 1-inch internal thread on all four sides. The internal threads are parallel/cylindrical and comply with the common standard ISO 7-1.

Yes, the crosspiece is approved and suitable for sprinkler and gas extinguishing systems as well as general industrial construction.

Yes, the crosspiece is galvanized and therefore protected against corrosion. It is suitable for use in irrigation systems.

At temperatures up to 120°C, the allowable operating pressure is 25 bar. For higher temperatures, up to 300°C, the maximum operating pressure is 20 bar.

Yes, the cross piece has DVGW approval and is suitable for gas installations.

The crosspiece is galvanized, which provides good corrosion protection. It is made of cast iron and complies with the DIN EN 10242 standard.

At a temperature of 150°C, the threaded fitting can withstand a maximum operating pressure of 20 bar. This value is valid up to 300°C.