Mold Remover, Mildew Remover, 500ml Flat Spray Bottle, Mold Spray

The Hotrega mold remover comes in a practical flat spray bottle. This is ergonomically designed and should be easy to handle for most users. Spraying from a distance of about 10 cm is easy to do.

No, wearing protective gloves is absolutely necessary. The HOTREGA mold remover can cause skin irritation. Please also wear eye protection.

The Hotrega mold remover can be used on wooden surfaces. However, due to the bleaching effect, we recommend testing the product in an inconspicuous place to rule out possible color changes.

Yes, the Hotrega mold remover is also suitable for ceilings. The flat spray bottle allows for targeted application. Pay attention to sufficient eye and skin protection to avoid splashes.

The active chlorine formula of the mold remover guarantees a quick and lasting effect. In the case of permanently recurring infestation, the cause of the mold growth should be investigated and remedied.

Yes, the Hotrega mold remover is specially designed to remove mold stains, mildew, and bacteria. The active chlorine formula removes these black dots powerfully and sustainably.

No, it is generally not necessary to re-grout after using Hotrega mold remover on silicone joints. The product cleans and bleaches the joints. Simply rinse thoroughly with clean water after the exposure time.

In case of severe infestation, you should repeat the process after the first exposure time of 20 minutes. Spray the product again on the surface and let it work. Then rinse thoroughly with water.

The Hotrega mold remover is suitable for many plastics, including PVC. Follow the instructions for use and, if in doubt, perform a small test in an inconspicuous place.

No, mold growth should not be pre-treated under any circumstances. This prevents the distribution of mold spores in the room. Spray the product directly onto the affected area.

Yes, a 500 ml bottle is sufficient for your area. The Hotrega mold remover is sufficient for about 5-10 m² depending on the infestation and the absorbency of the surface. This corresponds approximately to the size of an average bathroom.

To ensure effective application and reach all mold spores, the Hotrega agent should be sprayed from a distance of approx. 10 cm. It is advisable to move the wardrobe slightly forward to spray the surface optimally and then wash it thoroughly.

After spraying, the product should work for about 20 minutes. In case of heavy infestation, you can repeat the process after 10 minutes. Afterwards, the treated surface must be washed off with plenty of clean water.

The Hotrega mold remover contains sodium hypochlorite and is irritating. People with allergies or sensitive airways should only use the product in well-ventilated areas and with personal protective equipment. Always follow the safety instructions.

Yes, the Hotrega mold remover has an extra strong bleaching effect. This helps to visibly brighten discolored grout caused by mold.

The mold remover contains a highly concentrated active chlorine formula as an active ingredient. Therefore, a typical chlorine odor is noticeable during and after use. Ensure good ventilation.

The recommended exposure time is about 20 minutes. In case of heavy infestation, the process can be repeated after 10 minutes, the maximum total exposure time should not exceed 30 minutes. Then always rinse thoroughly with clear water.

Yes, the highly concentrated active chlorine formula of the mold remover has an extra strong bleaching effect. This ensures a visible lightening of the affected areas.

With light infestation and low absorbency of the surface, a 500 ml bottle is sufficient for about 5 to 10 m². (Roughly speaking: Under optimal conditions, up to 10 m² can be treated.)

The mold remover is suitable for wood and many plastics. For painted surfaces, we recommend testing the compatibility in an inconspicuous area beforehand. Then wash off with plenty of water.