Garden Furniture Oil 1 Liter, UV Protection Wood Finish, Outdoor Furniture Oil

The oil should be applied in dry weather and at temperatures between +5°C and +35°C. Direct, strong sunlight should generally be avoided, as this can negatively affect drying.

Yes, that's correct. The SCANDICCARE oil must be applied wet-on-wet at intervals of 15 to 30 minutes. The individual layers must not dry in order to ensure optimal penetration.

The oil can be used in dry weather as long as the temperature is between +5°C and +35°C. Processing is not recommended at colder temperatures in the fall below 5°C.

The oil penetrates quickly and deeply into the wood due to its exceptional penetration ability. The complete drying of the surface then takes about 24 to 48 hours.

This garden furniture oil has been specially developed as a care and natural oil for outdoor use. It is recommended for all wooden surfaces outdoors.

One liter of the oil has a yield of about 6 m² per coat. For the recommended 2-3 coats on 5 m², you will need approximately 1.5 to 2.5 liters, depending on the absorbency of the wood. One liter will not be sufficient for this. (Roughly calculated: For 5 m² of surface area and 2 coats, about 1.6 liters are needed.)

New, especially pressure-treated wood, should remain untreated in the first year. This promotes controlled drying and the optimal opening of the pores for subsequent oil treatment.

The original color of the wood is slightly intensified by the treatment and takes on a teak-colored hue. This hue weathers evenly over time without flaking.

With wood types containing tannin, such as oak, it is advisable to neutralize them with the SC-HOLZ-ENTGRAUER before oiling. This way, the wood is optimally prepared for oil treatment.

Yes, the oil penetrates deep into the wood, encloses the lignin and thus prevents moisture penetration and lignin loss. This leads to reduced swelling and shrinking of the wood, which reduces cracking.

After cleaning, for example with a wood gray remover, the wood must dry for at least two days. It is important that the wood is completely dry and absorbent before you apply the oil.

Yes, the SCANDICCARE garden furniture oil can be tinted with universal color additives for oil-based paints. An addition of 5 to 10 grams per liter of oil is recommended.

The oil is pigmented in teak color, but offers almost colorless protection. It slightly intensifies the original color tone of the wood. The tinting will weather off again over time.

No, varnishes or glazes must be completely removed before applying the garden furniture oil. The wood must then be thoroughly cleaned and dry for at least two days.

Yes, the oil is also suitable for already grayed wood. Before treatment, cleaning with a wood gray remover should be carried out. The wood must then dry for at least 2 days.

If your garden furniture has already been treated with another oil and is slightly grayed, you should first clean it with SC-HOLZ-ENTGRAUER. After that, this garden furniture oil can be used.

After the last coat, excess material must be removed with a clean cloth after about 30-60 minutes. If this is not done, the surface may remain sticky.

Experience shows that a repeat coat is necessary per year. The exact frequency depends on the weather conditions and the use of the wooden surfaces. The surface only needs to be cleaned for this.

The oil is pigmented in teak color, but the special pigmentation allows for almost colorless protection. The original color of the spruce wood is more likely to be intensified by the treatment, not darkened significantly.

For optimal and lasting protection of the larch wood, we recommend 2 to 3 coats. The oil is very suitable for native woods like larch.

The oil was specially developed for outdoor use and protects the wood from the inside against moisture and lignin loss. It reduces swelling and shrinking, does not form a film, and contains UV protection. For permanent protection, experience shows that an annual reapplication is necessary.

Yes, treating it with the oil intensifies the original color tone of the wood and thus also highlights the natural wood grain of your oak bench.

The oil penetrates deep into the wood due to its very good penetration ability, protects it from the inside and is not film-forming. This prevents chipping and undermining by moisture.

As long as the oil hasn't dried, you can clean brushes and rollers with paint thinner or cleaning gasoline. Dried oil can only be removed mechanically.

One liter of the oil is sufficient for about 6 m² per coat. For 10 m² and the recommended 2 coats, you would need about 3.3 liters. (roughly calculated: 10 m² x 2 coats / 6 m²/L = 3.33 L)

The SCANDICCARE garden furniture oil contains UV protection through special pigmentation. This protection delays the natural graying of the wood and slightly intensifies the original color tone.

Yes, the oil protects the wood from the inside by enclosing the natural lignin and thus repelling moisture. This significantly reduces the swelling and shrinking of the wood and prevents cracking, which contributes to the longevity of your furniture.

The oil penetrates the wood completely without forming a surface layer. This prevents moisture from penetrating, chipping, or flaking.

Yes, the oil contains a special pigmentation that provides UV protection and intensifies the wood color. It is not intended to allow the natural graying of the wood.

One liter of the oil has a yield of approx. 6 m² per liter with one coat. For 12 m² and with the recommended 2-3 coats, you will need about 2 to 3 liters. (Roughly calculated: With three coats, that would be about 18 m², so just over 2 liters for your shed.)