Charger 2.4 A ALG 18 V Li-Ion

The LED indicator signals the charging status and possible errors. A blinking or red indicator may indicate a battery fault or overheating. Please check the battery and the ambient temperature.

No, this charger is exclusively designed for our 18V Li-Ion batteries of the ALG series. It is not compatible with 14.4V or other voltages.

No, this charger is exclusively designed for Westfalia ALG 18V Li-Ion batteries. Other battery types like NiCd are not compatible and should not be used.

Yes, operation with a suitable extension cable is easily possible indoors. Make sure you have a sufficient cross-section and a dry environment.

The 2.4 A ALG 18 V charger is designed for quiet operation and has no active fan. Cooling is passive, which prevents annoying noises.

The charger is robustly built, which means a certain resistance in everyday work. Nevertheless, the cable connection should not be overstressed to ensure longevity.

A green LED signals that the battery is fully charged or that the charger is ready for operation. A red LED indicates the active charging process; blinking may indicate an error or a defective battery.

No, the charger has been developed exclusively for 18V Li-Ion batteries of the Westfalia ALG series. It is not compatible with 12V batteries.

Yes, the ALG 18 V charger is suitable for all 18 V Li-Ion batteries from the Westfalia system. The charging time varies depending on the capacity of the battery.

Yes, the charger is also suitable for smaller 18 V Li-Ion batteries, such as with 1.5 Ah. These are then charged faster than a 2.4 Ah battery.

Yes, the charger is robustly built. It can withstand the usual stresses of everyday workshop use.

Yes, the LED indicator on the charger signals the charging status and informs you as soon as the battery is fully charged. This ensures easy handling.

The charger is designed exclusively for 18V Li-Ion batteries. A 12V battery will not charge and the device will not be damaged, but there will also be no function.

The charger works optimally at room temperature. Extreme cold below 0°C or heat above 40°C can affect the charging process and shorten the life of the battery.

The ALG 18 V charger has an overcharge protection function. However, for longer periods of non-use, it is recommended to disconnect the device from the mains to minimize energy consumption.

No, the charger has intelligent charging electronics. This switches off automatically as soon as the battery is full and thus prevents overcharging.

The LED display is designed for easy handling and should clearly indicate the charging status even in brighter lighting conditions. This way, you have an overview of the progress.

You can easily recharge partially discharged Li-Ion batteries at any time. A complete discharge before charging is not necessary and is also not recommended for the battery life.

The charger is powerful with 70 W, which ensures fast charging. The product description does not provide information about the specific energy consumption or efficiency.

For a 2.0 Ah 18V battery, the charging time with this powerful 70 W charger is about 60 minutes. So your battery is quickly ready for use again.

A slight warming of the battery and charger during charging is normal and harmless. However, if the battery gets hot, stop the process and contact our customer service.

Yes, the charger is robustly built. It can therefore also be used in a workshop or basement environment without placing it on the floor immediately leading to damage.

No, the charger WF-936117 is specially designed for Westfalia ALG 18V lithium-ion batteries. It is not suitable for NiCd or NiMH batteries.

The charger is designed for fast charging a single battery in 60 minutes. For two 2.4 Ah batteries that are charged one after the other, you need to plan for about 120 minutes. (roughly calculated: 2 batteries x 60 minutes charging time).

No, the ALG 18 V charger is designed for use in dry indoor areas. It should be protected from moisture, rain, and direct sunlight.

The charger is designed for reliable maintenance of the battery condition. You can leave the battery in the charger without hesitation, even if it is already fully charged.

Yes, the charger is robustly built. It is designed for daily use in the workshop and can withstand a lot without being damaged immediately.

For a completely discharged 5.0 Ah battery, the ALG 18 V charger needs about 137 minutes for a full charge. That's about 2 hours and 17 minutes.

Yes, the charger is designed for fast charging and recharges an empty battery in about 60 minutes. It is powerful with 70 W and ensures quick continuation of work.

Yes, the charger is designed with an LED indicator for easy handling. It is intended to make the charging process intuitive and uncomplicated.