SDS Plus drill and chisel set 10-piece

The set contains flat, pointed and spade chisels with the dimensions 14 x 250 mm. These are well suited for various smaller chiseling work such as knocking out cable ducts or removing plaster.

The SDS Plus set is suitable for typical breakthroughs in masonry and concrete. For very large or load-bearing wall breakthroughs, special tools may be required.

The pointed chisel is designed for concrete work and can be used to break up smaller concrete slabs or for chiseling work. The carbide version ensures stability.

The carbide cutters of the drills are wear-resistant and suitable for hard materials such as natural stone. Pay attention to the correct speed and cooling.

Yes, the SDS Plus set is designed for all common rotary hammers with SDS Plus chucks. The drill bits and chisels are optimized for this type of machine and therefore fit without any problems.

Yes, the drills and chisels are also very suitable for brick walls. The carbide cutting edges offer the necessary robustness for this material.

The spade chisel can be used for rough plastering work. However, the chisels in the set are rather too large for very fine or filigree work on plaster.

The drill bits have an asymmetrical spiral shape that ensures optimal removal of the drill dust. This effectively transports the drill dust out of the hole even with deeper drilling, up to the maximum drill bit length of 260 mm.

Yes, the chisels are suitable for demolition work in concrete, stone and other hard materials. This also includes removing screed.

The drill bits in the set are equipped with a carbide cutting edge, which is extremely stable and wear-resistant. This ensures a long service life and effective work even on very hard concrete walls.

Yes, the increased breaking strength of the drills and chisels ensures safe use even under high stress in hard materials such as stone. This reduces the risk of tool breakage.

The use of coolant is recommended for drilling in hard materials such as concrete. This helps to avoid overheating the drill bit and extends its lifespan.

The 14mm drill bit in the set has a length of 260 mm. With it, you can create boreholes up to an effective depth of approx. 21-22 cm. For a "very thick" wall over 25 cm, this drill bit would not be sufficient in one pass.

Yes, the asymmetrical spiral shape of the drill ensures optimal drill dust removal. This is particularly advantageous with deeper holes to avoid clogging.

Yes, this drill and chisel set is explicitly suitable for materials such as brick and natural stone. The carbide cutting edges are designed for high stress in hard materials.

Yes, the included flat and spade chisels are well suited for removing old tiles and plaster. Their dimensions are suitable for such work.

Yes, it is recommended to free the tools from dust and flour after each use. This ensures a long service life and optimal function.

Yes, the largest drill in the set has a diameter of 14 mm and a length of up to 260 mm. With it, you can easily drill a 20 cm deep hole.

Optimal dust extraction reduces the falling of dust and dirt during overhead work. Nevertheless, safety glasses are always recommended.

Yes, the drill bits with a carbide cutting edge are designed for concrete and masonry. They are well-suited for typical drilling in house walls.